1. Home
  2. Brands
  3. Sommer
  4. Sommer Pro+ 2060 Direct Drive Garage Door Operator
Sommer Pro+ 2060 Direct Drive Garage Door Operator
Sommer Pro+ 2060 Direct Drive Garage Door Operator

Sommer Pro+ 2060 Direct Drive Garage Door Operator

Write a Review
Retail Price:$432.38
You Save:$57.65(13%)
Part Number: YS10249-00001
The Sommer Pro+ 2060 Garage Door Operator from Garage Door Supply Co is a versatile garage door opener that uses a direct drive design with a traveling motor that silently glides on a fixed chain. The 2060 Pro+ has a 600 Newton (3/4HP) motor and can be used on doors weighing up to 600 pounds. Direct Drive operator technology maximizes strength while minimizing moving parts and operator noise/vibration. This operator uses a flexible separate control unit housing that can be installed virtually anywhere in the garage (front, rear, or ceiling). Pro+ models are ideal for installations with limited back room or retrofit solutions where the building was not wired for a garage door operator ahead of time. The separate control unit housing provides flexibility and convenience.

Security and Safety:

  • 922.5 MHz radio controls with 128-bit encryption
  • Positive push-back by the operator in case of attempted forced entry
  • Optional buzzer and lock for additional security
  • Continuously adjusted force curves for maximum safety and obstacle detection
  • Operators adjust speed based on door balance and weight for optimal speed and safety
  • Monitored optical safety sensors included
  • Optional monitored safety edge can be added
  • 4-channel on board radio receiver for optional functions with 40-slot on board memory
  • Engineered to 125,000 cycles in beta stage with third-party certification
  • Mid-stop and automatic closing enabled
  • Interlock capable
  • 600 Newton Motor - Speeds up to 9.4” per second - maximum door weight 600 lbs
  • Monitored safety edge or optical safety edge capable
  • Alternate timing for internal and external lighting with radio channel 2
  • 12VDC power supply at the motor carriage and 24VDC power supply at the control housing
  • Homelink compatible
  • Mount the control housing anywhere a power outlet is available
  • The 24V connector wire between the control housing and rail is a low voltage wiring making for an easier installation (no electrician required)
Included in operator package:
  • Motor Carriage
  • Control housing with built-in wall controls
  • 16’ connector wire
  • 3-piece rail for doors up to 8' tall
  • Nickel-plated chain
  • One 4-button remote with visor clip
  • Wired safety sensors
  • Hardware for installation including door arm, ceiling bracket and straps
  • Manuals and low voltage wiring kit