CLOPAY Garage Door Bottom EPDM Rubber Weather Seal 100-ft. BULK ROLL

Buy Clopay CLO-400 garage door weather seal in this 100-ft. economy-priced roll (part number V2131-BK-W-100) from Garage Door Supply Company for installation on multiple Clopay steel garage doors. Clopay O-bottom weather seal is a made from durable EPDM synthetic rubber in a property design only for use on single-channel retainer Clopay garage doors. While the weather seal arrives flat, it becomes bulb-shaped after the 4-in. wide seal is folded in half and installed on the garage door bottom retainer by sliding on the L-shaped legs.

The 1 1/4-in. bulb that's created will protect uneven garage floors by creating a weather-blocking seal between floor and door. This seal will block warm weather and cold weather drafts, rain and blowing dust and dirt particles. EPDM rubber will survive extreme heat and temperatures as low as minus-50 degrees Fahrenheit. This 100-ft. roll is easy to cut to fit. Always add an extra foot when measuring each individual door width to accommodate shrinkage and trimming. Our friendly, knowledgeable staff welcomes questions from professional installers and DIY home and small business owners.

Installation Instructions for "Bulb" Shaped Astragal:

1. Raise door to open position. Place “C” clamps in both tracks directly below the door and tighten.
2. Remove old weather seal from the bottom of the door section. It may be necessary to remove screws holding weather seal to the retainer.
3. Make a bulb shape from the flat strip of weather seal by curling the ends together. The top of the bulb will resemble a “T”.
4. Insert “T” shape into retainer slot. See Fig 3. Slide the weather seal across the length of the door. NOTE: The weather seal will slide through the retainer slot easier if soapy water is applied.
5. Cut off excess weather seal flush leaving two extra inches from the edge of the door. Tuck extra weather seal into itself to allow for future shrinkage. If any screws were removed, replace now.